Batboard

hi folks,

Every time my Astro Saber 3 boots up, it displays error 09/10 along with a low pitch "boop" and repeats...

When i try to read the code plug is says: block checksum failed for SP tone PL block block. continue unpack anyway? yes / no

When i click yes, it says: no user function provided to convert block type ID for block with type 151. unpack failed. OK is the only thing i can click.

What can i do to fix this?

thanks,
Alex

Hightower wrote:09/10 is a secure hardware failure. Try removing the UCM and see what happens.

I agree, but removing the UCM will still cause the same error. (No module found.)

1: If it has a secure module, you will need to replace it
2: If it doesn't have a module, you need to disable secure in the codeplug. This may be an issue since your CPS/RSS is upset with the radio. What version are you using?

tpg

The Pager Geek wrote:

Hightower wrote:09/10 is a secure hardware failure. Try removing the UCM and see what happens.

I agree, but removing the UCM will still cause the same error. (No module found.)

1: If it has a secure module, you will need to replace it
2: If it doesn't have a module, you need to disable secure in the codeplug. This may be an issue since your CPS/RSS is upset with the radio. What version are you using?

tpg

Im using CPS R05.02.00

Also, I did find the UCM or something that looks like an encryption module?

Thanks for the quick responses guys...

But my CPS does not open the the code plug... it says the message I stated in the first post.


thanks
Alex

i tried takin out the ucm and then rebooting and that did not work.


so then i tried replacing w/ another ocm from my other as3 512k and that did not work either same 09/10 error code on start.

still wont read in cps r05.02.00, same message

Hightower wrote:Did you remove the UCM (encryption module) and then try reading the radio?

yes i did... twice