Batboard

Connected V.24 board to wireline and made cable to connect diu 3000.Diu 3000 transmits imbe ok but does not decode imbe receive.The rd line on v.24 shows clock pulses and does not change when receiving imbe.I tried v.24 card on a quantar with same results.The quantro is ver. 20 and quantar is ver 16.I do not have information on dip switches on v.24 card and now switch 1 is (on) on active port.V,24 light is also solid on quantro when diu is connected.I tried several configs on wireline with same results.Diu shows active rx light on analog only.Repeater is mixed mode.

I found problem looking at wireline configuration.The securenet/astro to wireline was disabled.changed to enable and Diu3000 works great on tx/rx now.

Hi, just a question : Do you have cable schema to connect V24 wireline on Quantar to DIU3000? Maybe cable reference ?

I posted the cable pinout to go from the DIU's COMM connector (DB-25) to the Quantar here:
http://batboard.batlabs.com/viewtopic.p ... 99#p244499