Page 1 of 1
Astro Spectra command board jumpers for non-RS232 operation
Posted: Wed Jul 08, 2009 2:41 pm
by motorola_otaku
While flipping through the Astro Spectra detailed service manual I stumbled across this table for moving
jumpers around on the
command board to enable non-RS232 operation from the DB15 accessory connector. It's been discussed before, but I can't find the thread and I don't think the exact jumper positions got posted anyway, so here you go:
Re: Astro Spectra command board jumpers for non-RS232 operation
Posted: Sat Oct 03, 2009 9:08 pm
by cahighwayman22
Do you have a layout of where these jumpers are located on the Command Board?
Trevor KI6KGN
Re: Astro Spectra command board jumpers for non-RS232 operation
Posted: Sat Oct 10, 2009 11:50 am
by PropellorHead
Ya, I have no clue where these jumper positions are and I'm in need of moving some of these pins around.
Any luck on a layout of the jumper positions?
Re: Astro Spectra command board jumpers for non-RS232 operation
Posted: Thu Oct 15, 2009 1:05 pm
by IMBEJames
There are a few jumper locations that vary depending on the revision of the board. Check the detailed service manual for the component layout or let us know what part number and someone here can help you out.
Re: Astro Spectra command board jumpers for non-RS232 operation
Posted: Thu Oct 22, 2009 2:58 pm
by cmdcomm
Did you ever get the layout of the board for this? I need to put 5 astro spectras in a new dispatch center.
Re: Astro Spectra command board jumpers for non-RS232 operation
Posted: Fri Oct 23, 2009 12:22 pm
by motorola_otaku
Component side:
Solder side:
This took me all of 15 minutes with the Detailed Service Manual. Surely y'all aren't completely helpless? ;p
