radius p 200

[smokey705]

I am having some problems trying to enter two different pl codes on one frequency. We have went in and entered both codes in the set up section. you can enter the rx code and when you get to the tx code it inserts the rx code. any ideas on this thanks.
smokey 705

[1 Adam 12]

Its been a million years, but if I'm reading you message right, you went and entered the 2 PL's you needed as two seperate RX & TX PL's. If I remember right the only way you can mix them on the 600/200 is to enter them together on one line... so instead of it reading in the PL table setup
123.0 TX and 123.0 RX and 127.3 TX & 127.3 RX
you actually have to setup that line as 123.0
TX and 127.3 RX in order to do what you want.
I never really did much with HT600/P200 but I believe thats the only way it will work.

[1 Adam 12]

Its been a million years, but if I'm reading you message right, you went and entered the 2 PL's you needed as two seperate RX & TX PL's. If I remember right the only way you can mix them on the 600/200 is to enter them together on one line... so instead of it reading in the PL table setup
123.0 TX and 123.0 RX and 127.3 TX & 127.3 RX
you actually have to setup that line as 123.0
TX and 127.3 RX in order to do what you want.
I never really did much with HT600/P200 but I believe thats the only way it will work.

[HumHead]

You remeber correctly. You have to enter your tone sets under PL - QC II configurationn (after you select your configuration option), and then choose one of the sets for each channel.

[Monty]

OR:

A simpler approch while in the RSS:

Looking @ the main menu:

<b><h2>1. Press F4
2. Press F2</h2>

Decide how many PL/DPL tones you need.

<h2>Select either F2, F4, F6, F8</h2>

Make your selection
in the <h2>RX & TX Fields</h2>

Then Exit

Monty




<font size=-1>[ This Message was edited by: [email protected] on 2002-01-29 14:28 ]</font>