Need Pinouts

motoelph · Post by **motoelph** » Sun Feb 24, 2002 7:53 am

I have a TLN2418A Metering Panel, I think it went to a MSF5000 repeater. I need the pinouts of the big connector on the bottom so i can use it with other stuff. Thanks if you have this, respond to [email protected]

Will · Post by **Will** » Sun Feb 24, 2002 11:18 am

That metering uint has a two charicter display works on a fourty pin cable from a mux buss in the radio's control board.
It is a specialized unit for the MSF5000 only.
Basicaly it is a minicomputer mux bus decoder and encoder.
The meter is a analog meter for reading voltages on the two test lead jacks.