NUCLEUS front panel freq programming

n_zero_ndp · Post by **n_zero_ndp** » Tue Jan 20, 2004 2:40 pm

Hello everyone,

Just got a NUKE-II 900meg 300w station for use as my repeater TX.... I have looked in the manual about how to enable front panel freq entry & it says to make sure switch 1 on S300 is ON. The problem is, where is this S300???
I only have the "USER MANUAL" at my disposal so I guess the info I need is in the MAINTENANCE manual...

Can anybody point me in the right direction??? Is it on the NIU card or the SIU? NAC software versions are: BOOT 2.0 & Application 4.03

TIA from a nuke noob

n_zero_ndp · Post by **n_zero_ndp** » Wed Mar 17, 2004 4:27 pm

Well......

To share what I finally found out - switch 1 of S751 near the front edge of the System Control Module card.

Strange, seems I might be talking to myself here......