Error 58: Radio Codeplug Error

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Post Reply
User avatar
brandon75181
Posts: 19
Joined: Tue Jan 27, 2004 10:00 pm

Error 58: Radio Codeplug Error

Post by brandon75181 »

I need some help. I was programming my SM120 with a few new channels. It seemed to work fine. When I noticed I forgot a channel. I went back to read the codeplugs so that I could add/change one, and it reads 100% but then pops up with ERROR 58: Radio Codeplug Error. Because of that error, it is not reading the freq's, so therefore I can't change or add another mode.

Any help with this problem is appreciated!

Brandon
[email protected]
Top
medic4145
Posts: 48
Joined: Thu Nov 13, 2003 9:28 am

Same problem

Post by medic4145 »

I had the same problem with a maxtrac, did the exact same thing you did. Ending up with a bad logic board, I really dont know how I did it ??? Any way I am having to send it out to have the board blanked and reinitialized. Good Luck ... You may want to try going to the service menu and moving the power settings up or down by one or two settings then save. Then try to read you codeplug. This was suggested to me by many on the great!!! batlabs board!!

Good luck
The only radio is a Motorola Radio!!
Top
User avatar
brandon75181
Posts: 19
Joined: Tue Jan 27, 2004 10:00 pm

Post by brandon75181 »

I tried to adjust the TX power settings. I think I did it right and it did not work for me. Any other ideas? I don't like the idea of a bad logic board.

PLEASE HELP ANYONE!!!
Top
Post Reply

Return to “General Motorola Solutions & Legacy Radio Discussion”