Minitor 1 and 3

n1iic · Post by **n1iic** » Tue Apr 09, 2002 10:12 am

Greetings. Is it possible to set the 1 to long tone?
What is the pinout for the base of the 3?

Thanks

Jason

gafd6913 · Post by **gafd6913** » Tue Apr 09, 2002 2:20 pm

Hi! It is possible to set up a Minitor 1 for long tone "B" decode, however, you need the group call decode option. Motorola used to make the kit for group call but I doubt that they still do. My suggestion would be to ask around to see if anyone would have an audio board with the long tone option already installed.
One question of my own, is it possible to configure a three tone minitor to do a long tone decode?

n1iic · Post by **n1iic** » Tue Apr 09, 2002 7:44 pm

There must be a way to strap the first reed high or low as it needs, and use the second reed as the long tone, but I don't have schematics and I am not sure i can figure it out.
BUT- I do know someone that can help.

Jason

Alan · Post by **Alan** » Wed Apr 10, 2002 7:34 am

The first reply was correct.
The Minitor I requires a group call modual to be installed (along with a few resistor and jumper changes).