HLN1206 Wildcard box intructions

rrfd43 · Post by **rrfd43** » Wed Aug 18, 2004 5:14 am

does anyone have a set of sys9000 wildcard box installation instuctions they can fax, email, or mail me? I just want to make sure I install it right. Thanks!

Post by Pj » Wed Aug 18, 2004 11:32 am

Go to http://www.batlabs.com and find the Syntor X9000 page. The pinouts are on that page.

JAYMZ · Post by **JAYMZ** » Wed Aug 18, 2004 2:00 pm

To back up my esteemed colleague...

http://www.batlabs.com/x9000.html is the page you are looking for.

rrfd43 · Post by **rrfd43** » Wed Aug 18, 2004 4:13 pm

hey I knew that was there, just wanted to see if there has any other info that could be useful to me in the instruction sheet. Thanks though.....

007 · Post by **007** » Wed Aug 18, 2004 10:02 pm

rrfd43 wrote:hey I knew that was there, just wanted to see if there has any other info that could be useful to me in the instruction sheet. Thanks though.....

Not to sound like a [rooster], but like what? It's pretty open and shut: 6 on/off, 2 momentary switches that can switch up to 1 amp to control relays downstream. The link above lists the wiring diagram, which shows the 8 control lines and 12v +/- for the back lights.

Are you looking for anything in particular?

rrfd43 · Post by **rrfd43** » Thu Aug 19, 2004 6:22 am

No, just wondering, and attepting not to burn up my truck.

Just thought someone may have some past experience 2 cents about it... Thats all.

Just got a big box of parts and before I smoked anything I tried to make sure there was nothing I might miss.

JAYMZ · Post by **JAYMZ** » Thu Aug 19, 2004 6:44 am

Make sure you keep the amount of power running into the wildcard down. Since everything will be run on relays fuse all the switches down to 1 amp or less. Or you'll end up like me. Mistaken colors in fuses meant a cooked DEK. And I mean cooked. It was only a 5 amp fuse too. Burnt the traces right off the board.

rrfd43 · Post by **rrfd43** » Thu Aug 19, 2004 12:20 pm

See I knew someone had some info that would be of value....Thanks!!!!

kf4sqb · Post by **kf4sqb** » Thu Aug 19, 2004 5:33 pm

Just a tip: you can, if desired, wire the lights in the wildcard to the dashlights of the vehicle. Then, the lights in the wildcard will dim/brighten with the dash lights. Works great!