GR900 to GM900 conversion

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Post Reply
wokka
Posts: 12
Joined: Sun Mar 03, 2002 4:00 pm

GR900 to GM900 conversion

Post by wokka »

this is linked to my question about the GM900 front panel thread, suppose i should have explained this way. Trying to convert the two radios found inside the GR900 for use, i have programmed the new frequencies to be used but i do not have any front panel control on either radio, any ideas, something i have missed in the RSS or possible pinouts?
Cheers
Tim
Top
wokka
Posts: 12
Joined: Sun Mar 03, 2002 4:00 pm

Post by wokka »

reading through the batlabs forum i have found how to convert these radios to be used after removing them from the repeater enclosure. Make sure you link pinouts 1+2, 9+10 to gain control of the front panel and enable the panel speaker.
Top
Post Reply

Return to “General Motorola Solutions & Legacy Radio Discussion”