Minitor V Nylon Case

[STicKman]

The nylon case supplied with the Minitor V appears to be manufactured for previous series of models in this line? The pager does not insert completely, its very snug and the flap cover is constantly putting pressure on the playback button. I also wish the case allowed use of the belt clip to insure the case stayed with the pager similar to the Minitor III.

Is there another after market case that would work better?

[nmfire10]

The whole point of the case is so it's not on the belt clip. The loop on the case makes sure it stays on the belt and doesn't break anything.

[redneck_1086]

i noticed that my minitor v didn't fit in the case too well either so what i did was cut the belt loop off and cut hole in the back of the case where the clip could slide thru, just like you wanted, and it works good and looks proffesional

[rfdlou]

Try raine company. I have used one for 4 years and found it to be very good. Metal clip & velcro flap. Nylon case has to break in, but then it form fits the pager. http://www.raineinc.com/CatItemDetail.a ... &SrcInfo=1

Good Luck,
Lou

[Al]

Although Motorola has recommended the RLN5699A or RLN5700A nylon carry case(only difference is the 5700A has the American Flag on it) they only became available to purchase today, and I'm waiting for my shipment to see whether they fit better than the ones I've seen referred to above(which obviously were not designed for the Min V). Even from M, the price isn't too bad; something like $11.00, give or take a little.