GM1200 Conventional Mode

[montegrande]

Hallo
I need help for use GM1200 in conventional mode!!!
when my radio start led green blink and a Z is in display.
There is a way to switch it in conventional mode and use for talk with HAM radio?? I need only 4 conventional channel!!


Please Help me

Max

[wmd]

Hello Just push the P button until the radio Go's into conventional mode then let go of the P Button

[montegrande]

OK!!!!!!!!!!!!!!

Radio is in conventional mode!!!!!!!!!!!!!!!!!!!!!!!!!!!!!


Thanks!!!!!!!!!!!


Max

[montegrande]

Sorry have another problem...

Now , in conventional mode radio transmit OK but i don't hear nothing... red led blink and no audio.....

My GM1200 have internal loudspeaker... pin 1 & 2 of Accessory Connector are Jumped..when radio start i Hear beep

[wmd]

Are you using DOS or DPS software to program the radio?

[montegrande]

..Was a stupid flag!!
Now i can hear...

but another problem!!!

I can Tx only 5 seconds... after a beep and..stop TX..

there is a timers? or a protection???

Please help me!

i use DPS R00.01.10 software.... dos rss 03.03.00 do not support this model!
Can you help me? If you wont i can send you a print of all configuration!

[Andreas]

Do a firmware update,this will fix the problem.

Andreas

[montegrande]

have find that is a timer TTs in network configuratin......is 0 sec and so after 5s alert cut off.. i set this value at max (60sec) and so i can talk for 60s but i need disable this options!!!
Can you help me to disable this function... I am in conventional mode...Why network timers are on???


Thks

Max

[Andreas]

Only flashing the radio into MC2100,will disable the timer complete!

Andreas