looking for the pin out on both the cdm1250 for use with the MC1000 remote mic. Using the red transmit button and handset/remote speaker. We had the unit hooked up and some remodling done and of course no one wrote down the wireing. So the wires are still connected to the CDM what I can see is the 2 for audio and then there are 3 others I guess would be for the tx audio.
On the MC1000 ther connectors are as follows PTT (com no nc) gnd RS232 (tx rx) AUDIO (tx+ tx- rx+ rx-) gnd MONITOR (no com nc).
While I am at it I also want to use a output such as the horn ring to trip lights hooked up to a relay if anyone can help with that.
CDM 1250 pin out using MC1000 remote
Moderator: Queue Moderator
-
stueyneumann
- Posts: 17
- Joined: Tue Feb 24, 2004 2:33 am
-
thebigphish
- Posts: 1477
- Joined: Sat Nov 29, 2003 10:10 pm
- What radios do you own?: AM/FM
the pin outs are readily available on the batlabs website for the accessory 20 pin connector as seen http://www.batlabs.com/htpro.html
and then Todd already answered this one here
just kiddin.
and then Todd already answered this one here
all information found with rather bad use of the search function, would hate to see what i can find if i ever become proficient at it!Wavetar wrote: Yep, that information is on Batlabs. You can easily figure it out between these two pictures:
http://www.batlabs.com/images/1550svc.gif
http://www.batlabs.com/images/proacc.gif
just kiddin.