is there a way to refirb a ht1000 mic

explorer1046 · Post by **explorer1046** » Fri Mar 10, 2006 9:28 am

Is there a way to take apart a ht1000 mic (NMN6193) and replace the bad/worn parts w/ new parts?

HLA · Post by **HLA** » Fri Mar 10, 2006 9:40 am

just the ptt button and the cord, the mic itself is sealed permanently.

phrawg · Post by **phrawg** » Fri Mar 10, 2006 7:53 pm

It WILL open upon application of a 3Lb persuasion tool at correct
point and at a velocity aproximating that of a normal hand swing.
Repairability at that point brings various opinions. Phrawg

PINEAPPLE · Post by **PINEAPPLE** » Tue Mar 14, 2006 12:10 am

I have HT1000 JEDI mics for sale used or new in the BOX at very reasonable prices............reply if interested....

Post by **wavetar** » Tue Mar 14, 2006 11:41 am

They pop open in a vice fairly easily...make sure your face isn't in the way!

Todd

explorer1046 · Post by **explorer1046** » Tue Mar 14, 2006 12:00 pm

after they are popped open, do you have to hot glue them back together?

phrawg · Post by **phrawg** » Wed Mar 15, 2006 10:40 am

or epoxy.... even some cyanoacrylate (super glue) might work. Phrawg

Tony Soprano · Post by **Tony Soprano** » Wed Mar 15, 2006 10:48 am

wavetar wrote:They pop open in a vice fairly easily...make sure your face isn't in the way!

Todd

This works for the Visar mic, too....but what do you do with it once it's open? Not much!

phrawg · Post by **phrawg** » Wed Mar 15, 2006 1:13 pm

WOW I just realized that last post here was #500.
oh well no big deal compared to those multi thousand fellows. Phrawg

FF/EMT/KC2NFB · Post by **FF/EMT/KC2NFB** » Wed Mar 15, 2006 1:25 pm

i opened one by prying it open around the edges. i have only done it to one and it opened fairly easy with very little damage. i used crazy glue to close it and you cant tell it was opened unless you look realy close. but as stated above they are sealed units not intended to be opened.