mts2000

[skipfd8]

I have a mts 2000 800 trunk i had gotten off of ebay. when i read the radio with rss the radio has been inhibited. I still programmed my info into the radio but it still just does the self check and then turns back off. Any one know how i can get this radio to work for my stuff or is it just a paper weight now? Thanks

[Rick Rock]

edit

[Rick Rock]

Is it a flashport radio?

Is it giving off a fail 01/93 code?

What software version are you using?

What's the model#?

[skipfd8]

The radio has been inhibited because it says so when i read the radio in the rss. The model # H01UCH6PW1BN. Th e flash code is0000080000002. When you turn the radio on it self tests and the screen goes blank.

[wavetar]

Normally, you would "reset" it by programming in a saved codeplug from before it was inhibited. Since you don't have that luxury, you're going to have to find another codeplug with the exact same model & flashcode, and clone it in.

Todd

[skipfd8]

well i tried cloning an exact same codeplug with the same flash code but it says it wont program because the radio has been inhibited. Any other suggestions? i am using the windows rss.

[wavetar]

well i tried cloning an exact same codeplug with the same flash code but it says it wont program because the radio has been inhibited. Any other suggestions? i am using the windows rss.

I assume you're using CPS version 1.13.00? It states in the "readme" file that once a radio has been written with that version CPS, it will no longer be able to be uninhibited by cloning an uninhibited codeplug.

I don't know if using an earlier version of CPS, or possibly even DOS RSS to do the cloning, would clear it at this point, but it's about all you can try.

Todd