Saber Programming Problem

cophamguy · Post by **cophamguy** » Thu Apr 13, 2006 6:05 pm

Ok here's the deal-

I have a saber 1, rib, rss, the works. I connected everything and powered up the radio and rib. I opened rss and attempted to read the radio and got a comm/ I/O error. The rss says to check the connections to the computer and try again. I have tried again...and again...and again. Same thing. I even tried a different computer. same thing.

what gives?

RESCUE161 · Post by **RESCUE161** » Thu Apr 13, 2006 8:17 pm

Try going into the setup screen via the F9 > F3 or vice versa...

Then see which COM Port it's set to. That is probably your problem.

cophamguy · Post by **cophamguy** » Thu Apr 13, 2006 9:12 pm

i'll do that, thanks.

also, i finally read the programming primer and i said i might have this problem if i use a computer with the wrong OS..I guess i shoulda read the primer FIRST

<sigh>

va3wxm · Post by **va3wxm** » Fri Apr 14, 2006 7:32 am

Yep. DOS only!