Saber programming

ASTROAL · Post by **ASTROAL** » Tue Jul 18, 2006 12:31 pm

I have ver.#07 software for saber ,I am unable to save file after reading radio.When I try to save the file it says no elements and no file.I put in the model # where it says file,then I hit f2 is that correct or am I supposed to put something else there?

AEC · Post by **AEC** » Wed Jul 19, 2006 6:30 pm

If you simply copied the entire RSS to disk, you did not create a path for the archive once the main directory was created.

You can select 'default' and see if there was 'something' the RSS used as it's archive path, or you can create your own and press F8 to save it, and if that works, try saving the codeplug again.

There are several Saber versions I have had that did not have the HD installation as part of the initial setup, but every path can be created once you have the basic file information saved to disk, and you are in that directory as well.

I can bring up my RSS manual, but it takes a while, but I may be able to Email you the information from the manual.

ASTROAL · Post by **ASTROAL** » Thu Jul 20, 2006 10:36 am

Thanks.I have the rss manual and I will have to check the installation process again.

ASTROAL · Post by **ASTROAL** » Thu Jul 20, 2006 2:29 pm

The problem is solved.I selected the default setting and it brought up the codeplug I previously saved.Thanks again for your imput.

AEC · Post by **AEC** » Thu Jul 20, 2006 5:09 pm

YEE HAA!!

Another radio brought back from the dead!

Glad you got it running again!

Saber programming

Saber programming

saber programminig

saber programming