Slight o.t

STEVE W · Post by **STEVE W** » Wed Aug 02, 2006 6:49 am

Can a piece of wire or blob of solder be used in place of a 000 ohm sm resistor being used as a jumper on a pc board of a control head head back.

THANKS
Steve

mr.syntrx · Post by **mr.syntrx** » Wed Aug 02, 2006 6:56 am

STEVE W · Post by **STEVE W** » Wed Aug 02, 2006 10:35 am

Thanks for the "yup" I put in a simple jumper and I solved my problem, see my posting about the HLN6432 Spectra remote control head back.

thanks
Steve W

wazzzzzzzzup · Post by **wazzzzzzzzup** » Fri Aug 04, 2006 8:35 am

DEFINATELY.

that was a common practice where i worked when the SMT eqpt would forget or otherwise not plop a 0 Ohn resistor in a place, i would snip a small piece of tinned wire, and pop it in place. it is alot quicker than putting in a request for a 0 ohm resistor from the cage, then getting it 30 minutes later.