Pin actuator inside of JEDI's ACC connector - how 2 replace?

wireless.friendly · Post by **wireless.friendly** » Mon Aug 21, 2006 12:16 pm

Hi all!

I am thinking about recasing my MTS2000, but new case comes with empty hole in ACC connector, i.e. pin actuator (which works as antenna switch for PSM; as I know) does not present!

See pictures:

How I can remove pin actuator from old case and insert to new case? I examine both cases, but still no have ideas how I can do that.

Please help!

Lake Effect · Post by **Lake Effect** » Mon Aug 21, 2006 1:01 pm

The actuator can be pushed out from the inside. It takes a bit of force but will pop out.

L.E.

wireless.friendly · Post by **wireless.friendly** » Mon Aug 21, 2006 1:33 pm

Lake Effect

This is valid operation? Nothing will damaged?

MTS2000des · Post by **MTS2000des** » Mon Aug 21, 2006 2:05 pm

if you use a dull pointed oblect and push directly on the tit, it will pop out. then just pop it in the new housing. (you may want to clean the rubber sealing boot on it).

Lake Effect · Post by **Lake Effect** » Tue Aug 22, 2006 4:13 am

Yep, vallid operation. I've changed many this way and no problem.

L.E.

wireless.friendly · Post by **wireless.friendly** » Tue Aug 22, 2006 6:05 am

I done it! Thanks 2 all!

But not sure that after few ejectings/insertings, case will hold it reliable.

Do not ejectings it w/o unnecessarily!