The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!
I habe a gp300 uhf 16ch with and rx problem, the radio does not have rx at all untill you key the ptt, monitor, or option buttom on the radio. After you key any of the buttoms radio performs Rx with out problems.
As Will states, forced monitor will place the radio in a 'different' state that requires a button press, but only then will the radio allow you to hear traffic....simply deselect FORCED MONITOR and reprogram and you should be good to go.
NOTE: You should also have normal MONITOR button use afterwards as well, so the receiver will open on button press but will not affect PLs programmed or actual channel reception in either PL/DPL or CSQ operation.
AEC wrote:As Will states, forced monitor will place the radio in a 'different' state that requires a button press, but only then will the radio allow you to hear traffic....simply deselect FORCED MONITOR and reprogram and you should be good to go.
NOTE: You should also have normal MONITOR button use afterwards as well, so the receiver will open on button press but will not affect PLs programmed or actual channel reception in either PL/DPL or CSQ operation.
I did that already, I turned the forced monitor Off and ON but the problem still. Radio has very good Rx 0.3 Micro Volts. But always have to press a monitor buttom to make it received, that after turn force monitor off. if force monitor is on pressing any buttom on radio will receive. remember radio has proper PL set.
