CDM1550 LS+ Programming Question

cfdeng3 · Post by **cfdeng3** » Thu Oct 12, 2006 12:34 pm

I have programmed hundreds of CDM1550's over the years. I just found one that is messing with me. When I write to the radio the 1st zone comes up as LS trunking despite being a conventional bank. It only has the 1st channel in that bank also.

After this happened a few times I deleted the zone rebuilt it and wrote the radio again. As you can imagine it is still showing up as a ls trunking zone.

ANY HELP?????

Post by **wavetar** » Thu Oct 12, 2006 2:26 pm

Make sure none of the conventional channels in the zone have the option board enabled in the advanced tab. If all else fails, send me your codeplug & I'll have a look at it.

[email protected]

cfdeng3 · Post by **cfdeng3** » Thu Oct 12, 2006 2:31 pm

Thats the problem!!!!!! THANKS

Nice catch.

Post by **wavetar** » Thu Oct 12, 2006 2:34 pm

Sweet, glad it was that easy.

Todd

RKG · Post by **RKG** » Fri Oct 13, 2006 9:14 am

Ditto on the solution; the first one I had to do it took me about 2 hours to figure this out.