Minitor IV Programming

sourapple613 · Post by **sourapple613** » Tue Mar 13, 2007 10:55 pm

I have a non stored voice pager Minitor IV. What would happen in these situations.
A. I enable SV in the engineer mode.. would that make it a SV pager??

B. What does Call Reminder do when you have a non SV pager??

C. It gives a warning message when setting the pager to reset after so many seconds because it is not a SV model. Does anything go wrong if i would set it like this?

D. Is there any way to get the pager to be selective call and scan both F1 and F2 for tones? Basically like scan with tone alert only.. just we want it to not talk to us until we get a call

Has anybody ever played around with the engineer settings?? Im curious as to what some of those things do but I dont want to create a brick out of a pager.

Thanks for you replies!

sourapple613 · Post by **sourapple613** » Wed Mar 14, 2007 11:40 pm

bump.... anybody have any ideas on any of those things...

tvsjr · Post by **tvsjr** » Thu Mar 15, 2007 4:44 am

1. I believe the SV IC is missing, thus no. Besides, you wouldn't have the playback button.
2. I suspect nothing.
3. Nope, just means you might miss a part of a call.
4. Nope, that feature wasn't availble until the Minitor V.