I've been trying to figure out what I've been doing wrong in setting up a scan list on a Model 2 XTS3000 (CPS 04.01.02).
The scan list has three members. If I'm on channel 3, keying up on channel 1 or 2 will trigger the scan. If I'm on channel 1 or 2 and key up channel 3 the scan will not trigger, but the other two channels will show up on scan. All settings appear to be the same and the Rx/Tx/PL settings are correct.
Any ideas as to what I'm doing wrong? Has anyone else ever had an issue like this..?
Scan list question XTS3K
Moderator: Queue Moderator
Scan list question XTS3K
spock7230
"That which doesn't kill you is going to hurt, really, really bad..."
"That which doesn't kill you is going to hurt, really, really bad..."
-
Tom in D.C.
- Posts: 3859
- Joined: Tue Sep 04, 2001 4:00 pm
- What radios do you own?: Progreso soup can with CRT
Re: Scan list question XTS3K
Sounds weird, but...
Do you have the Autoscan turned OFF in each
conventional personality you're scanning? That's
where I would start looking anyway.
Do you have the Autoscan turned OFF in each
conventional personality you're scanning? That's
where I would start looking anyway.
Tom in D.C.
In 1920, the U.S. Post Office Department ruled
that children may not be sent by parcel post.
In 1920, the U.S. Post Office Department ruled
that children may not be sent by parcel post.
Re: Scan list question XTS3K
It is now. I've tried it both ways...Tom in D.C. wrote: Do you have the Autoscan turned OFF in each
conventional personality you're scanning? That's
where I would start looking anyway.
I've also tried both dynamic and non-dynamic scan...
spock7230
"That which doesn't kill you is going to hurt, really, really bad..."
"That which doesn't kill you is going to hurt, really, really bad..."