Guys,
Are the tuning values for a systems saber and/or a saber stored in the RF modules or stored somewhere on the control board? I am doing some conversions and wondering if I will even have to put the radio on the service monitor once I swap out the RF modules. Thank you in advance.
Radio43
RF Tuning Values on Systems Saber???
Moderator: Queue Moderator
-
RADIO43
- Batboard $upporter
- Posts: 743
- Joined: Thu Oct 17, 2002 10:46 pm
- What radios do you own?: 900 MHZ APX4000
RF Tuning Values on Systems Saber???
In Time of Crisis, You will Not Rise to the Occasion but Rather Default to your Level of Training!
-
FireCpt809
- Posts: 1848
- Joined: Sat Jan 19, 2002 4:00 pm
- What radios do you own?: Alot..
Re: RF Tuning Values on Systems Saber???
The values are stored in the motherboard. But since you change the modules it would change what the settings that were stored were specific to what the band the radio was tuned for. Its always best to check whenever you service a radio to make sure the alignment hasnt changed
-
RADIO43
- Batboard $upporter
- Posts: 743
- Joined: Thu Oct 17, 2002 10:46 pm
- What radios do you own?: 900 MHZ APX4000
Re: RF Tuning Values on Systems Saber???
FireCpt809 ,
Thanks for the info. I figured it needed tuning but was hoping it didn't. Thanks again.
radio43
Thanks for the info. I figured it needed tuning but was hoping it didn't. Thanks again.
radio43
In Time of Crisis, You will Not Rise to the Occasion but Rather Default to your Level of Training!