MAXTRAC 300 BIP BEP !

[RonJeremy]

What is wrong when I get two bip at power up ? Sounds like a corrupt codeplug but I don't get any error message while reading radio...

Thank you for your help !

[n7maq]

What is wrong when I get two bip at power up ? Sounds like a corrupt codeplug but I don't get any error message while reading radio...

Thank you for your help !

Do you have the emergency jumper in place? If the cp is corrupt, you should just get one low beep IIRC. Also a lot of time you can read the codeplug with no problems. If it is corrupt, try going into the service menu, make a change (I always change the freq warp by 1, and then back to what it was) save it, then go change back. See if that gets rid of the error tone. I know that works on one of the radius/maxtracs SOMETIMES. I saw that here on the board, it is correcting a checksum error.

Good luck,

Jim

[RonJeremy]

Well it was just a cut wire on the acc plug.

Thank you Jim.

[KitN1MCC]

i have a few that due that