Have two D44MJA77A3CK radios. Heres the problem. When programed to decode PL, decode works ok. However, I can not disable the decode with the MON button. Programed either way, with or without PL decode, the MON button will not open up the squelch. Have I missed something in programming? Or jumpers somewhere.
Tom
Maxtrac PL Decode ??
Moderator: Queue Moderator
-
Josh
- Posts: 1931
- Joined: Mon Sep 03, 2001 4:00 pm
- What radios do you own?: APX4K, XTL5K, NX5200, NX700HK
Re: Maxtrac PL Decode ??
You have to hold down the monitor button for about 2 seconds in order for it to go into open squelch.WA0RTU wrote:Have two D44MJA77A3CK radios. Heres the problem. When programed to decode PL, decode works ok. However, I can not disable the decode with the MON button. Programed either way, with or without PL decode, the MON button will not open up the squelch. Have I missed something in programming? Or jumpers somewhere.
Tom
If it doesn't, you may have "busy channel lockout" enabled somewhere.
-Josh
Re: Maxtrac PL Decode ??
Josh,
Thanks much. You were correct. I had BCL set. Trying to hard the find it and kept looking over it.
Again, Thank you sir.
Tom WAØRTU
Thanks much. You were correct. I had BCL set. Trying to hard the find it and kept looking over it.
Again, Thank you sir.
Tom WAØRTU