CentraCom 2+ Programming Question

[Rod Farva]

I am reconfiguring a CC2 Plus for a small department and it has been a while since I have programmed these units. I have the FPP software and the RS232 card. If I remember correctly you have to move a jumper on the TOMI card but I can not remember which one it was. I do not have the RSS book on me. Anyone know this on the top of there head? Thanks

[KSP1401]

It might be JU63.

[d119]

You shouldn't have to move any TOMI jumpers. The jumpers on the RS232 card must be set properly to program a TOMI.

Are you sure the TOMI board that you're trying to program is equipped with EEPROMS and not UV Erasable EPROMS? If it's equipped with UV EPROMS, you cannot reprogram it using the RS232 card.

[Rod Farva]

I think they are UV. I have to use a shooter or something to that effect....

[Rod Farva]

I have it handled now, they are turbo tomi's and I just did not select the right card in the rss

[d119]

Turbo TOMI's eh... Is this a trunked console? What are you using for system timers?