GM300 PROGRAMMING GOOF UP HELP

anautofix · Post by **anautofix** » Sat Jan 05, 2008 3:42 pm

I HAVE 2 GM300 UHF RADIOS...LOANED THEM OUT ...THEY WERE 16 CHANNEL RADIOS...THEY WERE REPROGRAMMED USING MAXLAB SOFTWARE AND WERE TURNED INTO 32 CHANNEL RADIOS....NOW THERE IS NO DISPLAY NO RX NO TX.... THEY CHANNEL INFO SHOWS THE 32 FREQS PROGRAMMED..... CAN I GET THE RADIO BACK TO 16CH??? HELP I HAVE 2 BRICKS :>(

[email protected]

kf4sqb · Post by **kf4sqb** » Sat Jan 05, 2008 4:48 pm

At a guess, try blanking and re-initializing it. The topic of how to do so has been covered on the board several times.

HLA · Post by **HLA** » Sat Jan 05, 2008 10:15 pm

i'd make it reak simple and say the people that borrowed them just bought themselves some radios

kf4sqb · Post by **kf4sqb** » Sun Jan 06, 2008 1:51 am

HLA wrote:i'd make it reak simple and say the people that borrowed them just bought themselves some radios

He does have a good point there....

Post by **wavetar** » Sun Jan 06, 2008 8:33 am

They can be restored, using the information in this thread:

http://batboard.batlabs.com/viewtopic.p ... lank+board

They will both require complete tuning as per the service manual.

Todd

Max-trac · Post by **Max-trac** » Sun Jan 06, 2008 7:12 pm

GM300s can be made into maxtracs, did they change the firmware chip???
Read thru this to see if it was done correctly;
http://www.batlabs.com/gmmax.html

GM300 PROGRAMMING GOOF UP HELP

GM300 PROGRAMMING GOOF UP HELP

Re: GM300 PROGRAMMING GOOF UP HELP

Re: GM300 PROGRAMMING GOOF UP HELP

Re: GM300 PROGRAMMING GOOF UP HELP

Re: GM300 PROGRAMMING GOOF UP HELP

Re: GM300 PROGRAMMING GOOF UP HELP