CDM 1550 SCANNING

[SLASH40917]

I programmed a CDM uhf w/scanlist and 1 Priority channel with quick call on priority channel. This list has 5 selected personalities with only 1 priority and a closed pager channel included. When scan is selected it works fine and unmutes the channels when traffic is present and works correctly for about 2 minutes. Then for some unknown *(#k*^@ reson it will not unmute for the priority channel or any others when it should. Its like its sleeping after a few minutes of being on I've check the settings for all and it appears to be ok to my knowledge however it will not unmute.. Any idea's PLEASE its driving me crazy.. Thankx again gents! Chris

[jackhackett]

Try adding "selected" to the scan list. I've seen problems with radios not unmuting in scan if this wasn't in the list, don't ask me why... it's a moto-mystery.

[RKG]

Also note that trying to work a QC channel in scan tends not to work; the scan delay interferes with the QC timing.

[SLASH40917]

IL TRY THANK YOU VERY MUCH

[SLASH40917]

that ws it thankx didnt like the quick call pager freq thankx