I have one of these front mount units that has no RF output. The questions is, how do you get the case apart as there doesn't appear to have any screws, latches, etc?
Tron
CM-1550LS UHF Case
Moderator: Queue Moderator
CM-1550LS UHF Case
"Where the Old Soo crosses the New Soo, Duplainville, Wisconsin"
Re: CM-1550LS UHF Case
Tron wrote:I have one of these front mount units that has no RF output. The questions is, how do you get the case apart as there doesn't appear to have any screws, latches, etc?
Tron
Just pull on the side at the bottom, get it over the side where the mount goes and peel it off. Then you need a Torex bit (15 IIRC) to get the cover off below the plastic housing.
Jim
-
jackhackett
- Posts: 1518
- Joined: Tue Jun 10, 2003 8:52 am
Re: CM-1550LS UHF Case
It's a #20 torx. A flathead screwdriver under the edge works well to pop the cover off, you just need to get it over the part where the mounting screw goes in and it comes off easily.
Re: CM-1550LS UHF Case
OK, i got the covers off. Next question, how does the front panel come off so I can take out the main circuit board? Is there some place to pry or snap as the front part looks like its in 2 parts.
Tron
Tron
"Where the Old Soo crosses the New Soo, Duplainville, Wisconsin"