ex600xls help
Moderator: Queue Moderator
ex600xls help
I just recently obtained a ex600xls and in the process of programing the radio ran into some difficulties. I am currently using cps version 6.02.05. The rotary knob right now is set to Zone Selection (continuous) and I am not able to change the setting to anything else. I am trying to set it to Channel Selection (Continuous) however it will not change. The selection is there but i am unable to change it. I have checked all the other setting with no luck. I do have multiple zones set up so there is not any issued with that. The zone are set correctly with multiple channels in each zone. I just can figure it out. Anyone have any advise????
-
HLA
- Posts: 2334
- Joined: Mon Jul 11, 2005 8:15 pm
- What radios do you own?: HT1550's, X9000's, CDM1550's
Re: ex600xls help
if you want to email me the codeplug i'll look at if for you?
HLA
I never check PM's so don't bother, just email me.
I won't reply to a hotmail, gmail, aol or any other generic free address, if you want me to reply use a real address.
STOP ASKING ME FOR SOFTWARE OR FIRMWARE, I JUST FORWARD ALL OF THE REQUESTS TO THE MODERATORS
I never check PM's so don't bother, just email me.
I won't reply to a hotmail, gmail, aol or any other generic free address, if you want me to reply use a real address.
STOP ASKING ME FOR SOFTWARE OR FIRMWARE, I JUST FORWARD ALL OF THE REQUESTS TO THE MODERATORS
-
Batwings21
- Posts: 930
- Joined: Fri Jun 23, 2006 11:21 am
Re: ex600xls help
I'm not sure when it was, but the ability to change the knob from zone to channel select came about with a specific version of software.