CM300 PAGING

SLASH40917 · Post by **SLASH40917** » Fri Apr 04, 2008 3:21 pm

I HAVE A CM300 WITH A PAGING CHANNEL IN IT. THE CHANNEL IS CLOSED TO ALL TRAFFIC. WHEN THE TONES ARE HIT IT ALERTS CORRECTLY HOWEVER I CANNOT HEAR ANY TRANSMISSIONS. IT ALERTS AND THE CHANNEL REMAINS CLOSED NO RADIO TRANSMISSIONS ARE HEARD. WHAT AM I MISSING IN THE PROGRAMMING THANKX

HLA · Post by **HLA** » Fri Apr 04, 2008 4:09 pm

what's your alert tone reset set to? if it's set to auto then turn it off.

SLASH40917 · Post by **SLASH40917** » Fri Apr 04, 2008 4:32 pm

It is sset to auto reset. If not its keeps beeping forever i need it to beep a few times then open the channel when activated so transmissions can be heard

HLA · Post by **HLA** » Fri Apr 04, 2008 4:57 pm

try setting your squelch signaling to "or" or change around your mute rules

SLASH40917 · Post by **SLASH40917** » Fri Apr 04, 2008 5:34 pm

I switched the sq to or and now its a open channel. I need a box that states tx only personality. Like the Ht and CDM's have in the signaling advanced programming section. do you know where i can find it or what i can do

CM300 PAGING

CM300 PAGING

Re: CM300 PAGING

Re: CM300 PAGING

Re: CM300 PAGING

Re: CM300 PAGING