Motorola GP680-380 Problem!

[YT1DIM]

Moto GP380 problem with CPS

Hello people!

I have a problem with my motorola GP380 ex gp680 i flash it from GP680 MPT to GP380 radio is uhf i use a waris5t GM3XX (R03.10.03) firmware and H25RDH9AN6 codeplug now the radio is recognizes like moto GP380 model number H25RDH9AN6,software version R03.10.03,codeplug version 06.01 radio info from labtool softver is

Model Number H25RDH9AN6
Serial number: ////////////
ESN 000/00/000000
Software version: R03.10.03
Codeplug Version: 06.01
Last programmed 200710041153
Codeplug part No: 5107447A01
Firmware part no: 5107414A01R0113
Radio IC versions $14 $FE $06 $85
Regional identifier: EMEA

Now problem,when u try to read it with CPS R03.02.01 i get a message ,,Codeplug version not suported by this CPS" and after that ,,Unable to create layot for modelindex-1,cpStdVersion 03.00?

is this wring CPS for this radio or is old and i nedd a never or what?

[slavik]

CPS R03.02.01 for firmware R03.10.03 is old.
you must used CPS R03.08.03

[YT1DIM]

Ok,i find a CPS R03.07.04 and i success to read it and programme it but now don't have a receive,when i press i side button i open a squelc and hear a audio but i dont heve a receive,all pl,ctsss,dpl are disabled but nothing,te tx is quite fine ?

[slavik]

1.
from Relise Note for firmware R03.10.03
"...
CODEPLUG COMPATIBILITY : R03.10.02
CPS COMPATIBILITY: R03.08.03 and later
..."
You must use CPS R03.08.03

2. What tanapa was at radio GP680, non Rohs or Rohs?
Codeplug for Rohs and nonRohs tanapa can have differences.

[AlexR]

There are either WARIS or Lazarus hardware platforms in GP680/380 radios.
And they have different codeplugs due to
different IFs in receiver (45.100 and 44.850 MHz).
Try to check this with 250kHz shift on receive, if yes, look for codeplug you need.

[YT1DIM]

Ok people i try it and it' s work i transsmit on other radio with 250khz shift in + and i have a great receive on gp380 but how to make the radio to receive on right frequency now
i try older codeplug from (ENVN4019S but still is the same,here is some info from the radio CPS now.

[Andreas]

You have a frequency shift problem with your radio!
For the most models,you find Tanapas with A/B/C index.
In the most cases,the B/C Tanapas are right for the newer radio hardware.
Try to program the radio with one of these Lab codeplugs and test it.

Andreas

[YT1DIM]

Thanks people,Alex i success it's now working i put the older codeplug in it (ENVN4019S) and now works just fine.