Does anyone have a schematic for a saber converta com ?

Post by **cowboywildbill** » Wed Apr 30, 2008 7:48 am

Hi everyone, I am getting an older saber converta com. It isn't going to have a power cable/harness with it. Does anyone one know which pins I need to use just to power it for use as a charger? I don't need any of the other functions. I would just like to be able to charge the unit while it is in the vehicle. I can't seem to find a cable, that would be the easiest route. Thanks

FireCpt809 · Post by **FireCpt809** » Wed Apr 30, 2008 9:38 am

http://batboard.batlabs.com/viewtopic.p ... &hilit=SVA

Post by **cowboywildbill** » Wed Apr 30, 2008 12:54 pm

Sorry about that Fire Capt. I'm just an old retired Firefighter/Diver IAFF Local 1664.

I'll try to spell it better It is a Covertacom Model NTN5487B. It's the unit that mounts in a vehicle and allows you to charge and use the unit like a mobile unit. Could have a mike and antenae hooked up to it.
I need to know which pins are( - and +)on the unit and will power it up for charging. Thanks

Post by **cowboywildbill** » Sat May 03, 2008 9:42 am

Thanks for the link. That's what I needed.

Does anyone have a schematic for a saber converta com ?

Does anyone have a schematic for a saber converta com ?

Re: Does anyone have a schematic for a saber converta com ?

Re: Does anyone have a schematic for a saber converta com ?

Re: Does anyone have a schematic for a saber converta com ?