HT1250 programming

This forum is for discussions regarding all aspects of Motorola radio programming, including hardware, computers, installation and use of RSS/CPS, firmware upgrades, and troubleshooting. There are subforums for discussions of codeplugs, and also for software/firmware release notes and issues.

Moderator: Queue Moderator

Post Reply
EMTof1963
New User
Posts: 4
Joined: Fri Jun 20, 2008 1:26 pm

HT1250 programming

Post by EMTof1963 »

i have an ht1250 i have the frequencies programmed but i need to know how to program our databurst ( which is MDC Signaling) i have the three numbers 110 but where do i put it so when our databurst goes out it trips the tone. also i need it to show who is keying the mic. mdc decode please help
Top
Hightower
Posts: 976
Joined: Mon Sep 24, 2001 4:00 pm

Re: HT1250 programming

Post by Hightower »

Under Conventional | Signaling enable MDC

Also need to set up a MDC profile under MDC.
Top
Post Reply

Return to “Radio Programming”