BPR40 Magone Radio Problem

johnny1225 · Post by **johnny1225** » Mon Jun 23, 2008 4:40 am

I have a BPR40 VHF Radio. Freq. 151.1150 with a TPL of 186.2. My questions is that the TPL on the receiver side is not working, it is not blocking anything out. The tx TPL is working find, does anyone no where i should look on the board or what part it might be that is causing this problem. Thanks in advance

John

a_j_b · Post by **a_j_b** » Mon Jun 23, 2008 10:38 am

Did you verify it is programmed correctly?

com501 · Post by **com501** » Mon Jun 23, 2008 8:29 pm

Check your button programming, too. Might be you have the monitor enabled...

BPR40s are relatively new. You might check warranty and see if it is still covered, if so, if there is a board problem, send it to MexiRola. Its a $150 radio.

vb105 · Post by **vb105** » Sat Jun 28, 2008 4:51 pm

In the Conventional Personality settings, verify your PL Option is set as TPL.

Post by **wavetar** » Mon Jun 30, 2008 4:24 pm

I don't have the software handy to step you through it, but look around for a field to set the mute rule to "and"...sounds like it's set to "or".

Todd

BPR40 Magone Radio Problem

BPR40 Magone Radio Problem

Re: BPR40 Magone Radio Problem

Re: BPR40 Magone Radio Problem

Re: BPR40 Magone Radio Problem

Re: BPR40 Magone Radio Problem