Signal strength indicator

[benwell]

Hi, Im trying to find out how to enable the Signal strength indicator
for the motorola GP 360 radio.

can't seem to find out any info about it, Motorola seem to keep all
this secret.

[Will]

Maybe look for RSSI. Receiver signal strength indicator.

[benwell]

No, there is no mention of that in the cps,

i would like to have the bar displayed so when out and about, i can see if i am in range of the repeater etc

[MotoFAN]

This feature not available in GP360.

But I know that you can change some value in firmware binary file to enable it. I have no more details about, but absolutely sure. Just because my familiar do that.

[benwell]

On Motorola Website for the GP360 Spec, it claims to have this feature.

[MotoFAN]

On Motorola Website for the GP360 Spec, it claims to have this feature.

Please provide link on Moto web page where you read it.

I know that some pages declares this feature for GP360, but this is just error.

Actually no RSSI indicator in GP360.

P.S.
US market HT Series is better that EMEA market radios. In EMEA radios: no zones (!), no clock, no RSSI indicator, less convenient CPS...

[benwell]

Ok Thanks for the info.

would of been good if i could have enabled it.

Regards

Dave

[MotoFAN]

Ok Thanks for the info.

would of been good if i could have enabled it.

Regards

Dave

You must have programming cable, flash adaptor, flash tool and firmware file. And expirience to find correspondent value in binary file.