CDM1550LS+ Open Squelch Issue

[NSPD]

I have a CDM1550LS+ that is acting up after programming. I the radio seems to be in constant open-squelch mode, on all frequencies. The local repeater breaks squelch if I attach a little piece of Coax to the unit, but still the squelch is open and I have a blinking red LED.

The codeplug I formally had in this radio had frequencies slightly lower and higher than what is currently in the radio, so I don't think the issue is that it's not locking on the frequency. I have unassigned monitor from any buttons as well, so I am stumped on this issue.

Anyone have any ideas?

[Jim202]

If the radio was operating correctly before you changed frequencies, my first
instinct would be to set the squelch tighter. You will need the software to
adjust this some.

Jim

I have a CDM1550LS+ that is acting up after programming. I the radio seems to be in constant open-squelch mode, on all frequencies. The local repeater breaks squelch if I attach a little piece of Coax to the unit, but still the squelch is open and I have a blinking red LED.

The codeplug I formally had in this radio had frequencies slightly lower and higher than what is currently in the radio, so I don't think the issue is that it's not locking on the frequency. I have unassigned monitor from any buttons as well, so I am stumped on this issue.

Anyone have any ideas?

[NSPD]

Well, I got it fixed. I'm not sure exactly how, but I did.

Thanks guys!