Radius P200 Help...

[Bijoy]

Hi,

I picked up a Motorola Radius P200 from a junk seller, Can anybody guide me on the operating frequencies of this type radio.

The only Model No. mentioned on the front panel is " Radius P200"

The following nos. are observed:-

1. Bottom of the battery :-
NTN 5545 B
323 MU

2.Opening the radio, on the radio circuit unit on a sticker:-
NTN 4568C 01
MAL 9015

3. On the side of this unit is another sticker :-
NUD1412B

4. On the PCB are the nos.:-
NUD 1152 C3
NUD 6782 B1
B016 MAL

Thanks in advance
Bijoy

[Tom in D.C.]

Start here:

http://batlabs.com/ht6hack.html

Then go on to a search on this Board for P200.

[Satelite]

Hello :
According to the number NUD6782B = You should have a 2 watt VHF 146 to 162 mhz split.
Satelite

[MT2000 man]

On the P200 radios, (unless of course, the tags were not on the radio when bought), most of them come with the info already on the back. The info included on the back of the radio should be: the model number, serial number, as well as the info. on what band the radio is, along with the frequency. Any more info, goes as the others have already stated, do a board search, you will come up with a LOT of info.
Good luck !

[Bijoy]

Belated Thanks Folks ...
Though not much into electronics... as per this url ... http://batlabs.com/ht600pin.html
Can I just homebrew a cable, connect to the necessary pins at the P200 Radio end and the other end to the 9 pin male which will go to my computer and use the P200(low band) RSS ver D03.00.01 and program the radio for 2m use ???

Hope somebody can guide me if I am off track...

Thanks
Bijoy

[Al]

You'll need an interface(RIB) to insert between your programming cable and your PC's serial port. And you'll need a PC that runs at an appropriate speed taking into account the version number of your RSS. Early versions of the RSS used only a single timing mechanism to pace reads from and writes to the radio interface, while later versions used dual timing loops allowing them to run properly on faster PCs. You can try the LB version of the RSS that you have, but I doubt that it'll allow a VHF hiband radio to be read or written because of the noncompatible bandsplits built into the LB version.