DOES ANYONE HAVE A STEP BY STEP SHEET FOR INFO PURPOSES ON HOW TO BLANK THEN REINITIALIZE A MAXTRAC HLN9313 LOGIC BOARD?
I would like to change the bd from another band range to be put into another radio that had the hln9123a logic bd and go from low tier to high signaling options and increase the channels to 32.
Thanx in advance
EKLB
MAXTRAC LOGIC BD HLN9313 REINITIALIZATION ?
Moderator: Queue Moderator
Hi:
VERY IMPORTANT !!
Before you engage in the process, RECORD all the
Soft Pot values in the Old Board !!
This will save you alot of headaches & Time if you
decide to reinitialize a Virgin / New Logic Board.
I have the Instructions on [ How Too ] Re-initialize
a [ Blank ] Board so long as you have a Blank board
to begin with.
If you email me direct @ [email protected], I have
a data sheet showing the step by step proceedures
BUT I do not offer any [ Tools ] or { SW } you are on
your own there ! However, if you do not have the Service
Tools, you can always just replace the IC ( Not just the
Firmware 5.34 IC ) but the IC on the Logic Board, and that
too will be Blank.
MS
VERY IMPORTANT !!
Before you engage in the process, RECORD all the
Soft Pot values in the Old Board !!
This will save you alot of headaches & Time if you
decide to reinitialize a Virgin / New Logic Board.
I have the Instructions on [ How Too ] Re-initialize
a [ Blank ] Board so long as you have a Blank board
to begin with.
If you email me direct @ [email protected], I have
a data sheet showing the step by step proceedures
BUT I do not offer any [ Tools ] or { SW } you are on
your own there ! However, if you do not have the Service
Tools, you can always just replace the IC ( Not just the
Firmware 5.34 IC ) but the IC on the Logic Board, and that
too will be Blank.
MS