XTS2500I

This forum is for discussions regarding all aspects of Motorola radio programming, including hardware, computers, installation and use of RSS/CPS, firmware upgrades, and troubleshooting. There are subforums for discussions of codeplugs, and also for software/firmware release notes and issues.

Moderator: Queue Moderator

Post Reply
tac9461
New User
Posts: 4
Joined: Mon May 26, 2008 7:41 am

XTS2500I

Post by tac9461 »

I am new to the XTS2500 programming. I am just using it for conventional right now.

When I am on a channel the radio will not receive it (tx fine) but when I go into scanning it will pick it up fine.

What am I missing? Tnx
Top
AEC
No Longer Registered
Posts: 1889
Joined: Wed Dec 22, 2004 7:56 pm

Re: XTS2500I

Post by AEC »

If your radio is scanning, it may be set to strip PL on scan, that could be the reason for hearing it.

If the radio has a tone on that particular channel and you are not scanning it, then i would assume your PL/DPL tone/code is not set to the correct one, and you will miss it.
Top
Post Reply

Return to “Radio Programming”