CDM-1250 connections

This forum is for discussions regarding all aspects of Motorola radio programming, including hardware, computers, installation and use of RSS/CPS, firmware upgrades, and troubleshooting. There are subforums for discussions of codeplugs, and also for software/firmware release notes and issues.

Moderator: Queue Moderator

Post Reply
markscan
New User
Posts: 2
Joined: Wed Mar 11, 2009 1:30 pm

CDM-1250 connections

Post by markscan »

Hi all , I'm new at programming, so please forgive me if this question has been asked before. I'm going to program a CDM-1250. My programming cable has four different connectors. One looks like a microphone jack. Can I program using this method, or do I have to get to the back of the radio. Its in an ambulance console, so it will be easier if I could go in from the front. Thanks for any assistance!!

Mark
Top
Jim202
Posts: 3610
Joined: Sun Sep 09, 2001 4:00 pm

Re: CDM-1250 connections

Post by Jim202 »

You normally program the CDM through the mic jack unless it is remote mounted.

Jim


markscan wrote:Hi all , I'm new at programming, so please forgive me if this question has been asked before. I'm going to program a CDM-1250. My programming cable has four different connectors. One looks like a microphone jack. Can I program using this method, or do I have to get to the back of the radio. Its in an ambulance console, so it will be easier if I could go in from the front. Thanks for any assistance!!

Mark
Top
Post Reply

Return to “Radio Programming”