Motorola CDM1250LS+ Go ahead beep

[JimG]

I'm interfacing the above radio to a ROIP unit. The unit is used on an LTR system. If you key up the radio from the front microphone, the radio accesses the system and you hear a go ahead beep thru the front audio speaker, indicating is is OK to talk. If it doesnt aquire a channel, you get the denial tone, again thru the front speaker. ALL normal functions, Radio works great, HOWEVER, I need to get those tones down the ROIP unit to the remote dispatcher in another location. All ROIP connections are made thru the 16 PIN connector on the back, rx audio is from the de-emphasize pin (11, I think) For some reason the beep doesnt go thru this audio output. Audio is great, no beep though. I've also tried pin 1 of the mike jack, again good audio, no beep. The only 2 sources where I can get the beep are the front speaker and the 1 + 16 pin external speaker on the back. Both of those levels are way to high to use. ANY SUGGESTIONS, I've looked thru the software and cant seem to find anything??

[ve3nsv]

Is the radios accessory connector programmed for

Pin 3 - External PTT

And for filtered audio in the accessory configuration tab? I have interfaced the CDM mobiles to many local remotes and ROIP adapters and never had a problem.

I believe one of those two will be your issue.