SVR-200 Programming

[laramiecountyCERT]

Morning,
I have a SVR-200 that I need to program but it seems like there is no place to program DPL in the system for this unit. I was under the impression that the SVR-200 could do BOTH PL and DPL. This is for a remote link that is being installed in the truck along with a CDM1550. Any suggestions or tweaks for this unit going in other than the standard programming of the CDM1550? I have the spec sheet and the radio is already programmed (I think) for the unit but this setup run DPL instead of PL and I need the unit to be on DPL as well.
Thanks

[Josh]

Morning,
I have a SVR-200 that I need to program but it seems like there is no place to program DPL in the system for this unit. I was under the impression that the SVR-200 could do BOTH PL and DPL. This is for a remote link that is being installed in the truck along with a CDM1550. Any suggestions or tweaks for this unit going in other than the standard programming of the CDM1550? I have the spec sheet and the radio is already programmed (I think) for the unit but this setup run DPL instead of PL and I need the unit to be on DPL as well.
Thanks

The SVR200 only does PL.

There may be an aftermarket board from selectone you could install though.

-Josh

[laramiecountyCERT]

Thanks Josh, I will program for PL only then. Got a cable on order and will see what I can do.

[Josh]

Thanks Josh, I will program for PL only then. Got a cable on order and will see what I can do.

You ordered a cable? It's really easy to make one, just follow the pinout here on batlabs.com . It's just a mini headphone jack connecting to two pins on a DB25, connected to a Moto RIB.

Works great.

-Josh

[laramiecountyCERT]

Oh the cable is already made for programming, I need the cable for connecting to the SVR-200 and the CDM1550 that I am going to use. Sorry for the confusion.
Thanks