CM200 programmed with pin 4 set to external alarm and high. Mobile receives the call and acknowledges it with the 2 beeps. First the pin would not give me any voltage at all. I fiddled with settings a bit to no avail. Changed it to COR and then I had 12V full time on pin 4 anytime the radio was powered on. Then I reprogrammed it to External Alarm and now I have 12V full time on pin 4.
Any ideas???
CM200 External Alarm
Moderator: Queue Moderator
Re: CM200 External Alarm
Current firmware version?
Re: CM200 External Alarm
i imagine (hope) it would be the most recent, i took delivery on these radios last week
as it stands now motorola is shipping me 2 more radios, should have them tomorrow, hope they work ok. when i talked to the post sales support group they said there were a few calls about this last week... hope it's not a bad batch
as it stands now motorola is shipping me 2 more radios, should have them tomorrow, hope they work ok. when i talked to the post sales support group they said there were a few calls about this last week... hope it's not a bad batch
Re: CM200 External Alarm
2 new radios arrived today, with 4.x firmware in them, programmed exactly as the two above and they work beautifully. Gonna chalk this up to a defect in the firmware in 3.03.04