Hello guys, here's another question...
checking out the pinout of the accessory 25 pins connector, i can't seem to find the ptt?
I'm i missing something?
sorry for the noob question...
mcs2000 acessory ptt
Moderator: Queue Moderator
Re: mcs2000 acessory ptt
From http://batlabs.com/gm900.html
Pinout for the Accessory Connector One of the pins labeled I/O has to be programed for PTT.
1 SPKR+
2 INT SPKR+
3 SPKR-
4 DIGITAL GND
5 BUSY
6 BUS+
7 I/O 8
8 I/O 5
9 EMERGENCY
10 ANALOG GND
11 FIL AUD OUT
12 AUX RX IN2
13 MIC IN
14 SW B+
15 IGNITION
16 I/O 2
17 LH RESET
18 BUS-
19 SCI RX DATA
20 I/O 4
21 I/O 3
22 RSSI OUT
23 EXTERNAL MIC IN
24 AUX TX IN2
25 UNIV IO OUT
Pinout for the Accessory Connector One of the pins labeled I/O has to be programed for PTT.
1 SPKR+
2 INT SPKR+
3 SPKR-
4 DIGITAL GND
5 BUSY
6 BUS+
7 I/O 8
8 I/O 5
9 EMERGENCY
10 ANALOG GND
11 FIL AUD OUT
12 AUX RX IN2
13 MIC IN
14 SW B+
15 IGNITION
16 I/O 2
17 LH RESET
18 BUS-
19 SCI RX DATA
20 I/O 4
21 I/O 3
22 RSSI OUT
23 EXTERNAL MIC IN
24 AUX TX IN2
25 UNIV IO OUT
Re: mcs2000 acessory ptt
Actually in the MCS2000 it's hard-set to pin 21.
Todd
Todd
No trees were harmed in the posting of this message...however an extraordinarily large number of electrons were horribly inconvenienced.
Welcome to the /\/\achine.
Welcome to the /\/\achine.
Re: mcs2000 acessory ptt
ok wavetar... so do i ground pin 21 and it will transmit?
Re: mcs2000 acessory ptt
Yes.mmaciel wrote:ok wavetar... so do i ground pin 21 and it will transmit?
No trees were harmed in the posting of this message...however an extraordinarily large number of electrons were horribly inconvenienced.
Welcome to the /\/\achine.
Welcome to the /\/\achine.