I have 2 maxtracs. The one that works has no signalling capability the other non functioning radio does have signalling capability. Question is: can I enable the MDC in the functioning radio? The options are not even in the rss when read via the computer..
Brian
Maxtrac Signal & MDC enable
Moderator: Queue Moderator
-
sparky2842
- Posts: 30
- Joined: Wed Feb 22, 2006 5:47 pm
-
Josh
- Posts: 1931
- Joined: Mon Sep 03, 2001 4:00 pm
- What radios do you own?: APX4K, XTL5K, NX5200, NX700HK
Re: Maxtrac Signal & MDC enable
Probably not. What's wrong with the "non working" radio? if it's not the command board, you may be able to do a swap granted the radios are the same frequency range and you can then do a full alignment as the soft-pot values will not match.sparky2842 wrote:I have 2 maxtracs. The one that works has no signalling capability the other non functioning radio does have signalling capability. Question is: can I enable the MDC in the functioning radio? The options are not even in the rss when read via the computer..
Brian
-
sparky2842
- Posts: 30
- Joined: Wed Feb 22, 2006 5:47 pm
Re: Maxtrac Signal & MDC enable
The non working one will not power up. I went to use it one day and nothin'. Does not smell like smoke and nothing looks burnt. I think it got a surge from lightning as there was a storm before this happened..
