CP 110 reset

This forum is for discussions regarding all aspects of Motorola radio programming, including hardware, computers, installation and use of RSS/CPS, firmware upgrades, and troubleshooting. There are subforums for discussions of codeplugs, and also for software/firmware release notes and issues.

Moderator: Queue Moderator

Post Reply
kens
Posts: 229
Joined: Mon Sep 10, 2001 4:00 pm

CP 110 reset

Post by kens »

I was programming CP 110's using ver 2.00 software. 2 of the radios now show alternating red/yellow led indications and attempts to read have the following message: "Warning radios memory is corrupted. Perform factory reset option to correct this problem." How do I do this or does it mean a trip back to M.
Thanks to all.
Ken
Top
kens
Posts: 229
Joined: Mon Sep 10, 2001 4:00 pm

Re: CP 110 reset

Post by kens »

I finally found it. Reset is done by holding down ptt and both side buttons until the second series of beeps is heard. I had to do the reset twice before I got the radio programmed. The program still requires multiple tries to get it to read or write.
Top
Post Reply

Return to “Radio Programming”