MTS2000 fault

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Post Reply
gmilhouse
New User
Posts: 14
Joined: Wed Feb 04, 2009 7:12 am

MTS2000 fault

Post by gmilhouse »

Hi guys,

Today I was given a MTS2000 from the local volunteer fire brigade to see if I can get it working. They have since upgraded to a XTS2500 so no biggie if I cannot repair it.

The problem is upon power up the LCDis full of all of the pixels and symbols and the radio wont tx or rx. I have tried to read the cp without success. The radio also makes a weird humming noise then after about 20 seconds it powers down. After a short time it will start up again and remain on however with the screen still full with no TX RX or anything else.

Any ideas?

Thanks

Greg
Top
Post Reply

Return to “General Motorola Solutions & Legacy Radio Discussion”