New question Solved

JerryS · Post by **JerryS** » Mon Feb 01, 2010 8:32 am

I am going to build a programing cable for my astro saber. I have done some searching. What would be the ideal wire that I could use for the radio to rib.

JerryS

Bill_G · Post by **Bill_G** » Mon Feb 01, 2010 8:42 am

continuous wire

No, but really - small gauge stranded takes a beating better than solid. IOW telephone cable and CAT5 are great for occasional cables, but not daily use. Use some old serial cable. Tinselated mic cord is a pain to solder.

motorola_otaku · Post by **motorola_otaku** » Mon Feb 01, 2010 9:55 am

I use 4 conductor shielded with ground telco cable. To play it safe, I always use the ground wire for actual ground. Heat-shrink the ends and around the solder connections on your D-sub connectors (if you don't use crimp) and they'll last forever.

JerryS · Post by **JerryS** » Mon Feb 01, 2010 10:27 am

Just read a other post about cables. I think Ill use a cat5 crossover cable that I have in storage. it is stranded and 3ft long. Just tined it up and it works great

Jerry

JerryS · Post by **JerryS** » Mon Feb 01, 2010 1:08 pm

Ok on the rib to astro pic over at the lab. am I looking at the back of the radio or the frount of the universal conecter?

On pins 4 and 11 is it a simple jumper?

kf4sqb · Post by **kf4sqb** » Mon Feb 01, 2010 8:28 pm

Jerry, I just replied to your other post on this subject, then found this post. Please refrain from multiple postings on the same subject. Keep it all in one thread to keep down clutter on the board.

On to your question. The view seen on the 'Lab is of the back of the radio. Also, yes, pin 4 to pin 11 is a simple wire jumper. This jumper is required to provide "bias" to parts of the RIB. In essence, the RIB is "turned off" without the jumper.

JerryS · Post by **JerryS** » Tue Feb 02, 2010 5:55 pm

kf4sqb wrote:Jerry, I just replied to your other post on this subject, then found this post. Please refrain from multiple postings on the same subject. Keep it all in one thread to keep down clutter on the board.

I can understand and appreciate it. Sense it is all based on the same subject I will keep my question here.

JerryS

JerryS · Post by **JerryS** » Thu Mar 11, 2010 9:25 pm

I am looking for the springy type pins that go in to the connector for a microphone that mounts on to the radio.

I have seen them on the web but I have gotten lost and now I can not find the web site.

Has anyone seen or know were to get them?

Dr. Frankenstein
aka JerryS

JerryS · Post by **JerryS** » Sat Mar 13, 2010 9:14 am

Well I found what I was looking for at this link: http://tech.am/2007/06/25/building-a-us ... la-radios/

So if anyone needs one or two they are also avalble at digi-key

Dr. Frankenstein

New question Solved

New question Solved

Re: Type of wire for programing

Re: Type of wire for programing

Re: Type of wire for programing

Re: Type of wire for programing

Re: Type of wire for programing

Re: Type of wire for programing

Type of wire for programing (New Question)

Re: New question Solved